SICK GMS815P-PS-3G

14 GMS815P-PS-2G/-3G · Supplementary Operating Instructions · 8016234 V2.0 · © SICK AG
Installation
Subject to change without notice
3.1 Safety information
3.1.1 Safety during transport and assembly
3.1.2 Protection against dangerous sample gases
If the sample gas can be dangerous to health, combustible and/or corrosive:
▸ Make sure no dangerous situations can arise should a gas leak occur.
▸ Check
– whether a gas detector must be installed at the installation location
– whether the enclosure must be purged continuously with a neutral gas during oper-
ation (with monitoring the discharged purge gas as required).
Install appropriate additional devices as necessary.
▸ Check gas paths regularly for leak tightness.
CAUTION: Risk of injuries
The weight of the enclosure can cause injuries when the device is not lifted in
an ergonomical way.
During transport and assembly:
▸ Consider the weight of the enclosure before lifting (→ p. 33, §6.3).
▸ Call in further personnel as assistants as required.
CAUTION: Risk of injuries
There is a risk of injuries should the enclosure drop down due to the weight of
the device and through hard, protruding enclosure parts.
During transport and assembly:
▸ Wear safety shoes. Use non-slip gloves.
▸ Handle the device carefully and safely. Secure during transport. Avoid falls
and collisions.
▸ Call in further personnel as assistants as required.
NOTICE: Risk of damage
▸ Do not use gas connections and cable inlets as lifting points.
NOTICE: Risk through transport safety devices
▸ Remove transport safety devices before start-up (→ p. 15, §3.2.3).
Otherwise electronic components can overheat during operation.