SICK TR10 Lock

H
Figure 16: Alignment of safety switch and actuator, variant 2
°
Use 1 ... 5mm for distance “G”.
G
DANGER
Hazard due to lack of effectiveness of the protective device
In the case of non-compliance, it is possible that the dangerous state of the machine
may not be stopped or not stopped in a timely manner.
b
After mounting, make sure that the actuator cannot be raised above the extended
guard locking pin.
b
After mounting, make sure that the safety switch and actuator do not collide when
opening or closing.
Figure 17: No raising
above guard locking pin
Figure 18: No collisions
between safety switch
and actuator
5 MOUNTING
22
O P E R A T I N G I N S T R U C T I O N S | TR10 Lock 8019972/1CS1/2022-07-20 | SICK
Subject to change without notice