Mower FA
- 15 -
3. TECHNICAL SPECIFICATIONS
The equipment, towed by the tractor by means of a three-point hitch of the rst
category, acts on the turf to be mowed owing to the high rotation speed of three
sharp blades driven by belts. These are mechanically driven by the tractor power
take-o by means of a PTO drive shaft.
The following table displays the salient technical data of FA mowers
4. MACHINE USE
INTENDED USE
The FA mower has been designed to be used exclusively in the agricultural
sector, for mowing grass.
The mower is usually used during the day; if night-time use or in conditions of
reduced visibility are required, use the tractor’s lighting system or an auxiliary if
necessary.
The operator must:
• Carefully check the machine before each use.
• Check the tightness of all the screws daily and tighten them if necessary (see
tightening table sec. 11.1).
• Check that the metal structures are in a good condition and, if necessary,
repair them.
• Make sure that the snap hooks of the PTO shaft guard retaining chains are
coupled to the appropriate slot so that the plastic guard is secure and does
not rotate with the PTO drive shaft itself.
• Before leaving the tractor, and before any maintenance, engage the parking brake,
stop the engine, remove the ignition key from the dashboard and keep it safe.
When the machine is running, the blades are in rapid rotation: keep a safe
distance to prevent accidental contact with them or with any objects projected
from the rear of the mower.
The equipment is not suitable for use in sectors other than agriculture.
TECHNICAL SPECIFICATIONS
MOD Power PTO Operational width Cutting height Blades Blade speed
Coupling
type
Weight
FA Hp kW rpm mm Inch mm Inch No. rpm Cat. kg Lbs
1200 15 - 60 11 - 44 540 1200 47 20 - 110 0.8 - 4.5 3 280 I 178 392
1500 15 - 60 11 - 44 540 1500 59 20 - 110 0.8 - 4.5 3 280 I 196 432
1800 15 - 60 11 - 44 540 1800 70 20 - 110 0.8 - 4.5 3 280 I 214 472
2100 15 - 60 11 - 44 540 2100 82 20 - 110 0.8 - 4.5 3 330 I 330 728
B
C
A
To Next Page
Loading...