Distributed I/O device 6DL2804-xxxxx
Hardware Installation Manual, 03/2014, A5E00378896F-03
19
• When installing control and measuring devices in the Ex enclosure, keep to the
instructions in the relevant product descriptions and the technical specifications in the
data sheets.
• All control and measuring devices installed in the enclosure must be separately certified
for the relevant hazardous zone.
• Run the tests prescribed in the relevant national regulations for the installed control and
measuring devices.
• Install and operate the distributed I/O device in hazardous areas according to the
specifications of the EC-type examination certificate according to ATEX and these
operating instructions or the standards and directives valid in your country.
• Assembly, installation, commissioning and maintenance may only be performed by
qualified personnel.
• The devices and installed components must only be used for their intended purpose.
Siemens Controls
To Next Page
Loading...
Need help?
General
