Siemens 6ES7131-6BF00-0DA0 - Page 17

Operating mode DI
3.2 Parameters/address space
Digital input module DI 8x24VDC HS (6ES7131‑6BF00‑0DA0)
Manual, 03/2015, A5E35243810-AA
17
The following parameter settings are possible for each operating mode:
Table 3- 1 Configurable parameters in DI operating mode
Parameters
Value range
Default
Configu-
ration in
RUN
Effective range with configuration
software
HSP0127 for
STEP 7 (TIA Portal);
HSP0229 for
STEP 7;
PROFINET IO GSD
file
PROFIBUS
DP GSD file
Potential group
• Use potential group of the
left module
• Allow new potential group
Use potential
group of the left
module
no Module Module
Operating mode
1
• DI / Oversampling
• Counting
— no Module Module
Diagnostics
No supply voltage L+
• Disable
• Enable
Disable yes Module Module
Diagnostics
Short-circuit to ground
• Disable
• Enable
Disable yes Module Module
Channel enabled
• Disable
• Enable
Enable yes Channel Channel
Input delay
• None
• 0.05 ms
• 0.1 ms
• 0.4 ms
• 0.8 ms
• 1.6 ms
• 3.2 ms
• 12.8 ms
• 20 ms
3.2 ms yes Channel Module
2
Pulse stretching
• None
• 0.05 s
• 0.1 s
• 0.2 s
• 0.5 s
• 1 s
• 2 s
None yes Channel —
3