Siemens 6ES7131-6BF00-0DA0 - Page 18

Operating mode DI
3.2 Parameters/address space
Digital input module DI 8x24VDC HS (6ES7131‑6BF00‑0DA0)
18 Manual, 03/2015, A5E35243810-AA
Parameters
Value range
Default
Configu-
ration in
RUN
Effective range with configuration
software
HSP0127 for
STEP 7 (TIA Portal);
HSP0229 for
STEP 7;
PROFINET IO GSD
file
PROFIBUS
DP GSD file
Hardware interrupt:
rising edge
• Disable
• Enable
Disable yes Channel —
3
Hardware interrupt:
falling edge
• Disable
• Enable
Disable yes Channel —
3
1
When configuring with HSP0229 for STEP 7 or with a GSD file, the operating mode is specified by selecting the module
name.
2
Due to the limited number of parameters at a maximum of 244 bytes per ET 200SP station with a PROFIBUS GSD
configuration, the configuration options are restricted. If your PROFIBUS Master supports the "Read / write data record"
function, you can set this parameter via data record 128.
3
If your PROFIBUS Master supports the "Read / write data record" function, you can set this parameter for each channel
via data record 128.