Siemens 6ES7131-6BF00-0DA0 - Page 55

Oversampling (OVS) operating mode
5.2 Parameters/address space
Digital input module DI 8x24VDC HS (6ES7131‑6BF00‑0DA0)
Manual, 03/2015, A5E35243810-AA
55
5.2.3
Explanation of parameters
Potential group
Specifies whether the a light BaseUnit with incoming voltage supply is located in this slot
(see system manual ET 200SP Distributed I/O System
(http://support.automation.siemens.com/WW/view/en/58649293)).
Operating mode
At the module level, specifies the operating mode in which the module's channels are
operated.
● DI (Page 13) / Oversampling
● Counting (Page 28)
When configuring with HSP0229 for STEP 7, the operating mode is specified by selecting
the module name.
Sampling rate
Specifies the number of subcycles per isochronous data cycle.
Diagnostics: No supply voltage L+
Enabling of the diagnostics for no or insufficient supply voltage L+.
Diagnostics: Short-circuit to ground
Enabling of the diagnostics if a short-circuit of the actuator supply to ground occurs.
Channel enabled
Determines whether a channel is enabled or disabled. If a digital input is disabled, the
module ignores its signals.