Siemens 6ES7153-2BA10-0XB0 - Configuring the Isochrone Mode

Functions
8.6 Isochrone mode
ET 200M
Operating Instructions, 04/2022, EWA-4NEB7806006-09
169
8.6.2 Configuring the isochrone mode
Procedure
1. Settings on the CPU:
"Object properties" of the CPU > tab "Synchronous cycle interrupts"
– Set the CPU synchronous cycle interrupt
– Select the DP master system being used
– Select the desired process image partition
– Recommendation for the delay time:
Use the default settings.
Figure 8-21 Synchronous cycle interrupts dialog box