Siemens 6ES7153-2BA10-0XB0 - Page 23

Brief instructions on commissioning
2.1 Commissioning on PROFIBUS DP
ET 200M
Operating Instructions, 04/2022, EWA-4NEB7806006-09
23
Necessary components
The following figure shows you which ET 200M components you require for the
commissioning example.
Figure 2-1 ET 200M components for the example configuration
①
to the DP master
⑤
SM 321
②
Slot
⑥
IM 153-2
③
Mounting rail
⑦
Power supply PS 307
④
SM 322
⑧
PROFIBUS cable with bus connector
Order numbers for the example configuration
Number
Item
Order number (Siemens)
1
Mounting rail
e.g.
6ES7390-1AE80-0AA0
1
PS 307 power supply with jumper
e.g.
6ES7307-1BA00-0AA0
1
Interface module IM 153-2
6ES7153-2BA01-0XB0
1
DI module SM 321
e.g.
6ES7321-7BH01-0AB0
1
DO module SM 322
e.g.
6ES7322-8BF00-0AB0
2
20-pin front connector with screw contacts
6ES7392-1AJ00-0AA0
x m
PROFIBUS DP cable with bus connectors
depending on design
x m
Cable for grounding the rail with 10 mm² cross section and
cable lug suitable for M6,
length depending on local factors
commonly available
Various
M6-screws and nuts
(length dependent on location)
with suitable screw driver
commonly available
1
Screwdriver with tip width 3,5 mm
commonly available
1
Screwdriver with tip width 4,5 mm
commonly available
1
Side cutters and wire stripping tools
commonly available