Assignment planning
3.1 Structure variants for PROFIBUS DP
ET 200M
Operating Instructions, 04/2022, EWA-4NEB7806006-09
35
non-redundant configuration
* SIPLUS modules for use in expanded environmental conditions
In the table, IM 153-2 stands for IM 153-2 (6ES7153-2BA81-0XB0 or 6ES7153-2BA82-0XB0)
SIPLUS modules
For the outdoor area under the product names SIPLUS special S7-300 modules are available.
You can use these under expanded environmental conditions. Expanded environmental
conditions mean:
• can be used from –25 °C to +60 °C
• occasional, brief condensation is permitted
• increased mechanical load permitted
In the functional scope and in the technical data, the SIPLUS modules correspond to the
"standard" modules.
The SIPLUS S7-300 modules have their own order numbers. These are based on those of the
"standard" S7-300 modules, starting however with "6AG1…" instead of "6ES7…".
For more information on these modules, refer to the reference manual "S7-300 automation
system, module specifications
(http://support.automation.siemens.com/WW/view/en/8859629)".
You´ll find more information on SIPLUS and contact partners for this area in the Internet
(http://www.automation.siemens.com/siplus/index_76.htm).
Reference
• You´ll find detailed information regarding the functions and properties of the IM 153-2 in
chapter "Functions (Page 128)" and in the appendix "Functions (Page 128)".
• You´ll find detailed information on mechanical and climatic environmental conditions for
operating the ET 200M in chapter "General technical specifications of the reference
manual "S7-300 automation system, module specifications
(http://support.automation.siemens.com/WW/view/en/8859629)".
• The IM 153-2Bxx1 is not just an interface module for the ET 200M, but also for the bus
connections DP/PA-link and Y-link. For the configuration variant options please refer to the
"DP/PA Link and Y Link bus links
(http://support.automation.siemens.com/WW/view/en/1142696)" operating instructions.
See also
Compatibilities between the IM 153-x (Page 241)