Siemens 6ES7153-2BA10-0XB0 - Page 85

Connecting
5.4 Wiring the power supply and modules
ET 200M
Operating Instructions, 04/2022, EWA-4NEB7806006-09
85
Design of the Shield Contact Element
The shield contact element consists of the following parts:
• a clamp with 2 screwed bolts for fixing to the rail
(order no.: 6ES7390-5AA00-0AA0) as well as
• The shield terminals
Depending on the cable cross-sections used, you must use the following shield terminal:
Table 5- 5 Assignment of cable cross-sections and terminal elements
Cable and shield diameter Shield connection terminal
order no.:
2 lines with in each case 2 to 6 mm shield diameter
6ES7390-5AB00-0AA0
1 line with 3 to 8 mm shield diameter
6ES7390-5BA00-0AA0
1 line with 4 to 13 mm shield diameter
Bus cable
6ES7390-5CA00-0AA0
The shield contact element is 80 mm wide with space for two rows each with 4 shield
terminals.
Installing the Shield Contact Element
Install the shield contact element as follows:
1. Push the two bolts of the fixing bracket into the guide on the underside of the rail. Position
the fixing bracket under the modules to be wired.
2. Bolt the fixing bracket tight to the rail.