Siemens 6ES7153-2BA70-0XB0 - Page 197

Interrupt, error and system messages
9.1 PROFIBUS DP
ET 200M
Operating Instructions, 04/2022, EWA-4NEB7806006-09
197
Channel-specific error messages
Table 9- 8 Error type of the channel-related diagnosis in accordance with the PROFIBUS standard
Error type
Error text
Meaning
Remedy
00000B
0D
reserved
00001
B
1
D
Short circuit
Short circuit, e.g.:
• Sensor lines short circuited in accordance with P potential
• Sensor lines short circuited in accordance with M poten-
tial
• Output lines short circuited in accordance with P poten-
tial
• Output lines short circuited in accordance with M poten-
tial
•
Output lines short circuited in accordance with ground
Correction of the pro-
cess wiring, M circuit, P
circuit
00010
B
2
D
Low voltage
Supply voltage is below the tolerance range
Correction on the
power supply, HART:
analog output current
established
00011
B
3
D
Overvoltage
Supply voltage is above the tolerance range
Correction on the
power supply
00100
B
4
D
Overload
the output stage is overloaded
Correction tuning of
module / actuator,
HART: analog output
saturated
00101
B
5
D
Excess tempera-
ture
the output stage is overloaded and has become too hot
Correction tuning of
module / actuator
00110
B
6
D
Wire break
Wire break, e.g.:
• Signal line to a sensor interrupted
• Signal line from an actuator interrupted
• Sensor power line interrupted
Correction of the pro-
cess wiring
00111
B
7
D
High limit ex-
ceeded
Value is above the over range
Correction tuning of
module / actuator
01000
B
8
D
Low Limit ex-
ceeded
Value is below the under range
Correction tuning of
module / actuator
01001
B
9
D
Fault
Error, e.g.:
• Load voltage on output
• Encoder supply
• Hardware error in the module
• Shield welded on or jammed
•
Life span of the switching element reached
Exchange the module
01010
B
to
01111B
10
D
to
15D
reserved