EasyManua.ls Logo

Siemens 6ES7153-2BA70-0XB0 - Page 35

Siemens 6ES7153-2BA70-0XB0
271 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Assignment planning
3.1 Structure variants for PROFIBUS DP
ET 200M
Operating Instructions, 04/2022, EWA-4NEB7806006-09
35
non-redundant configuration
redundant configuration
* SIPLUS modules for use in expanded environmental conditions
In the table, IM 153-2 stands for IM 153-2 (6ES7153-2BA81-0XB0 or 6ES7153-2BA82-0XB0)
SIPLUS modules
For the outdoor area under the product names SIPLUS special S7-300 modules are available.
You can use these under expanded environmental conditions. Expanded environmental
conditions mean:
can be used from 25 °C to +60 °C
occasional, brief condensation is permitted
increased mechanical load permitted
In the functional scope and in the technical data, the SIPLUS modules correspond to the
"standard" modules.
The SIPLUS S7-300 modules have their own order numbers. These are based on those of the
"standard" S7-300 modules, starting however with "6AG1" instead of "6ES7".
For more information on these modules, refer to the reference manual "S7-300 automation
system, module specifications
(http://support.automation.siemens.com/WW/view/en/8859629)".
You´ll find more information on SIPLUS and contact partners for this area in the Internet
(http://www.automation.siemens.com/siplus/index_76.htm).
Reference
You´ll find detailed information regarding the functions and properties of the IM 153-2 in
chapter "Functions (Page 128)" and in the appendix "Functions (Page 128)".
You´ll find detailed information on mechanical and climatic environmental conditions for
operating the ET 200M in chapter "General technical specifications of the reference
manual "S7-300 automation system, module specifications
(http://support.automation.siemens.com/WW/view/en/8859629)".
The IM 153-2Bxx1 is not just an interface module for the ET 200M, but also for the bus
connections DP/PA-link and Y-link. For the configuration variant options please refer to the
"DP/PA Link and Y Link bus links
(http://support.automation.siemens.com/WW/view/en/1142696)" operating instructions.
See also
Compatibilities between the IM 153-x (Page 241)

Table of Contents

Related product manuals