Remote operation
7.2 Operating via AMS Device Manager
SITRANS LR250 with mA/HART
Operating Instructions, 10/2019, A5E32220602-AG
103
Calibration Schedule [see Calibration Schedule (4.5.)]
● Calibration Interval
● Time Since Last Calibration
● Time Until Next Calibration
● Activation of Reminders
● Reminder 1 before Calibration (Required)
● Reminder 2 before Calibration (Demanded)
Electronic Temperature
● Electronic Temperature
● Lowest Value
● Highest Value
Wear
● Powered Days
● Poweron Resets
See Wear via SIMATIC PDM (Page 86) for more detail.
7.2.3 Communication
Navigate to Communication to read the following:
Tag; Manufacturer’s ID; Device ID; Product ID; Device Revision; EDD Revision; Universal
Command Revision
7.2.4 Security
Navigate to Configure/Setup > Security to access:
Remote Access [see Remote Access (6.1.)]
Note
If access control is changed to limit remote access, it can only be reset via the handheld
programmer. See Access Control (6.1.1.)
.
● Write Protect (read only)
● Access Control
Local Access [see Local Access (6.2.)]
● Local Write Protected
● PIN to Unlock
See also Password Protection (Page 105).
To Next Page
Loading...
