Appendix A: Technical reference
A.2 Echo Processing
SITRANS LR250 with mA/HART
236 Operating Instructions, 10/2019, A5E32220602-AG
Hybrid
Uses the Center algorithm for the top part of the vessel, and the CLEF algorithm for the part
nearest the vessel bottom, according to the setting for
CLEF range.
CLEF (Constrained Leading Edge Fit)
● Uses the leading edge of the echo.
● Is used mainly to process the echo from materials with a low dK value.
In an almost empty flat-bottomed vessel, a low dK material may reflect an echo weaker than
the echo from the vessel bottom. The echo profile shows these echoes merging. The device
may then report a material level equal to or lower than empty.
The CLEF algorithm enables the device to report the level correctly.
Example: CLEF off: Position set to Hybrid
Vessel height: 1.5 m; CLEF range set to 0 (Center algorithm gives the same result.)
vessel bottom echo selected
Example: CLEF enabled
Vessel height: 1.5 m; CLEF range set to 0.5 m
To Next Page
Loading...
