8 Physiologic Function
Instructions for Use 8 - 5
To adjust the ECG trace:
● Select More and then select Physio.
○ For systems without a touch screen, press Physio on the keyboard.
Adjust the wave
amplitude of the trace
(Available only when Manual Gain is enabled on the system configuration menu)
System Config > Physio System
Increase or decrease the wave amplitude.
● Rotate [Gain] to select Gain Min or Gain Max.
Gain.
○ For systems without a touch screen, select Increase Gain or Decrease Gain on
the image menu.
Increase Gain. Decrease Gain.
Position the trace up or
down on the image
screen
Reposition the trace.
● Rotate [Position] to select Position Min or Position Max.
Position.
○ For systems without a touch screen, select Move ECG Up or Move ECG Down.
Adjust the scrolling
speed of the trace
(Available during 2D-mode only)
Select a setting.
● Rotate [Sweep Speed].
○ For systems without a touch screen, rotate [Menu].
Note: During Doppler or M-mode, the trace has the same scrolling speed as the
Doppler spectrum or M-mode sweep.
To Next Page
Loading...
