Siemens AOP30 - Parameter Reset to Factory Settings

Commissioning
3.5 Parameter reset to factory settings
Cabinet Modules Operator Panel AOP30
Operating Instructions, 04/2014, A5E03263551A
33
3.5
Parameter reset to factory settings
The factory settings represent the defined original status of the device on delivery.
Resetting the parameters to the factory settings means that all the parameter settings made
since the system was delivered are reset.
Resetting Parameters via AOP30
Set parameter filter to "Parameter reset":
<MENU> <Commissioning/Service> <Device commissio
ning>
<OK
> <30: Parameter Reset> <OK>
Reset all parameters to factory settings:
Factory settings for all th
e device parameters are restored.
Note
When the parameters have been reset to the factory settings, initial commissioning needs to
be carried out.