Siemens AOP30 - Menu: Parameterization and Data Sets

Control via the operator panel
4.4 Menu: Parameterization
Cabinet Modules Operator Panel AOP30
40 Operating Instructions, 04/2014, A5E03263551A
4.4
Menu: Parameterization
You can adjust the device settings in the Parameterization menu.
The drive software is modular. The individual modules are called DOs ("drive objects").
Depending on the device configuration, the following DOs may be present more than once in
a SINAMICS S120 Cabinet Modules system:
•
CU_S
General parameters for the Control Unit (CU320
-2)
•
B_INF
For infeed via Basic Line Module
•
S_INF
For infeed via Smart Line Module
•
A_INF
For infeed via Active Line Module
•
VECTOR
Drive control in vector control mode
•
SERVO
Drive control in servo control mode
•
TM31
Terminal Module TM31
•
TM150
The TM150 temper
ature sensor module
•
TM54F
The TM54F terminal module
Note
Parameters with identical functions may exist with the same parameter number in more than
one DO (e.g. p0002).
Depending on your requirements, you can choose between two AOP display types:
1. DO selection
In this display, you can pre-select a DO. Only the parameters for this DO are then listed.
(The expert list display in STARTER only uses this DO view)
2. All parameters
All the parameters present in the device are listed here. The DO to which the parameter
currently selected belongs (inverted) is displayed in curly brackets in the top left of the
screen.
In both cases, the set access level governs which parameters are displayed. You can set the
access level in the "Safety inhibits" menu, which is called up using the key button.
The parameters for access levels 1 and 2 are sufficient for simple applications.
At access level 3 "Expert", you can change the structure of the function by interconnecting
BICO parameters.
In the data set selection menu, you can choose which of the data sets chosen is currently
DISPLAYED.
Data set parameters are designated by a "c", "d", "m", "e", or "p" between the parameter
number and parameter designator.
When a data set parameter is changed, the data set selection dialog appears.