Siemens AOP30 - Page 8

Table of contents
Cabinet Modules Operator Panel AOP30
8 Operating Instructions, 04/2014, A5E03263551A
4.8 Operation via the operator panel (LOCAL mode) .................................................................. 57
4.8.1 LOCAL/REMOTE key ............................................................................................................. 58
4.8.2 ON key / OFF key ................................................................................................................... 58
4.8.3 CCW / CW changeover .......................................................................................................... 59
4.8.4 Jog .......................................................................................................................................... 59
4.8.5 Increase setpoint / decrease setpoint ..................................................................................... 59
4.8.6 AOP setpoint .......................................................................................................................... 60
4.8.7 Lock AOP LOCAL Mode ........................................................................................................ 61
4.8.8 Acknowledge error from the AOP ........................................................................................... 61
4.8.9 CDS setting via AOP .............................................................................................................. 61
4.8.10 Timeout monitoring ................................................................................................................. 61
4.8.11 Operator input inhibit / Parameterization inhibit ..................................................................... 62
4.9 Saving the parameters permanently ...................................................................................... 63
4.10 Parameterization errors .......................................................................................................... 63
4.11 Faults and alarms ................................................................................................................... 64
5 Maintenance and servicing ....................................................................................................................... 67
5.1 Replacing the backup battery ................................................................................................. 67
5.2 Loading the new operator panel firmware from the PC .......................................................... 69
Index ......................................................................................................................................................... 71