Siemens bt300 - Parameters (M3)

Chapter 4 - Parameters and Menu Structure
Parameters (M3)
35 | 180
Siemens Industry, Inc.
Siemens BT300 HVAC Drive
DPD01809
Building Technologies
2016-06-07
Temperature inputs monitoring (M2.9)
The Temperature Inputs monitoring values are the actual values of the temperature inputs connected using slot C,
D, or E. If no sensor is available, the monitoring values do not exist.
The Temperature Inputs monitoring values are presented in the following table:
Table 12: Temperature Inputs Monitoring.
Structure
Parameter
Unit
ID
Description
M2.9.1
Temp Input 1
ºF
50
Measured value of temperature input 1.
M2.9.2
Temp Input 2
ºF
51
Measured value of temperature input 2.
M2.9.3
Temp Input 3
ºF
52
Measured value of temperature input 3.
Parameters (M3)
The Parameters group is a collection of parameters that are used during installation and commissioning. The
parameters group is used for configuration of the application in better detail than the Startup Wizard alone.
The parameters menu and application contain the following parameter groups:
Table 13: Parameter Groups.
Menu and Parameter group
Description
Motor Settings (M3.1)
Basic and advanced motor settings.
Start/Stop Setup (M3.2)
Start and stop functions.
References (M3.3)
Frequency references setup.
Ramps and Brakes (M3.4)
Acceleration and deceleration setup.
I/O Config (M3.5)
Input/Output (I/O) configuration.
Fieldbus DataMap (M3.6)
Fieldbus data out setup.
Prohibited Freq (3.7)
Prohibited frequencies setup.
Limit Superv (M3.8)
Programmable limit controllers.
Protections (M3.9)
Protections configuration.
Automatic Reset (M3.10)
Automatic reset after fault setup.
Timer Functions (M3.11)
Setup of time of day operation based on real time clock.
PID Controller 1 (M3.12)
Configuration of PID Controller 1. Used for motor control or external usage.
PID Controller 2 (M3.13)
Configuration of PID Controller 2. Used for external usage.
Multi-Pump (M3.14)
Configuration for multi-pump usage.
Fire Mode (M3.16)
Configuration for fire mode usage.
Appl. Settings (M3.17)
Parameters for regional settings and application.
ByPass (M3.18)
Parameters for Electronic Bypass option (when used).
Motor Settings (M3.1)
This structure contains basic (such as motor nameplate data) and advanced (such as pre-heat function) motor
settings.