Need help?Do you have a question about the Siemens SIMATIC PN/BACnet LINK and is the answer not in the manual?
General| Product type designation | SIMATIC PN/BACnet LINK |
|---|---|
| Supply voltage | 24 V DC |
| Protocols | PROFINET, BACnet |
| PROFINET interface | 1 x RJ45 |
| Operating temperature | -20 ... 60 °C |
| Certifications | CE, UL, cUL |
| Data Transfer Rate | 10/100 Mbit/s |
| Protocol | BACnet |
Provides an overview of the operating instructions and their purpose.
Lists supplementary documents for the PN/BACnet LINK and how to access them.
Covers warning notice system, qualified personnel, and proper use of Siemens products.
Details Siemens' approach to industrial security and recommendations for product updates.
Describes the purpose of the PN/BACnet LINK as a communication gateway.
Details the general and BACnet-specific characteristics and capabilities of the device.
Illustrates a basic system configuration and explains the role of each component.
Lists the necessary hardware and software components for the PN/BACnet LINK.
Explains the concept of BACnet server objects and client object references.
Illustrates data flow for BACnet server and client communication paths.
Provides essential guidelines for safe and compliant installation of the device.
Details permitted mounting positions, ambient conditions, and spacing requirements.
Describes how to mount the PN/BACnet LINK on a standard mounting rail or control panel.
Covers safety precautions for electrical connections and wiring best practices.
Covers power supply, functional grounding, and electrical isolation details.
Explains how to establish network connections for PROFINET and BACnet.
Outlines the basic steps for commissioning the PN/BACnet LINK using TIA Portal.
Provides an overview of the steps for configuring the device in TIA Portal.
Details how to set up the device and network connections in the TIA Portal.
Explains how to configure the BACnet/IP interface, server, and client settings.
Details how to configure the device object and I/O objects for BACnet server functionality.
Explains how to configure client-specific parameters, monitoring, and device references.
Describes how to verify and compile the device configuration for consistency.
Details the meaning of the status LEDs for operating state and PROFINET diagnostics.
Provides an overview of diagnostic messages sent to the S7 controller and their causes.
Instructions for updating firmware and resetting the device to factory settings.
Steps for replacing a faulty device and guidelines for recycling and disposal.
Covers product designation, engineering, installation, supply voltage, and input current.
Details the specifications for PROFINET IO and BACnet interfaces.
Specifies operating temperature, humidity, and lists standards, approvals, and certificates.
Details CE marking, EMC requirements, and general approvals for the device.
Provides contact addresses, service and support options, and online resources.
To Next Page