Application planning
5.2 Installation location
PN/BACnet LINK
46 Operating Instructions, 10/2017, A5E39895543-AA
Installation location
Selection of the installation site / installation
You can install the PN/BACnet LINK either in a control panel or on a standard mounting rail:
Installation in control cabinet / device connection box
The device is intended for installation in a control cabinet or in a device connection box.
It is important to note that installation in a control cabinet or device connection box is
essential for compliance with the UL regulations.
The control cabinet / device connection box must satisfy the regulations regarding fire-
protection housing.
Ensure that all cables and leads that protrude externally are equipped with adequate strain
relief.
To Next Page
Loading...
