Siemens SIMATIC PN/BACnet LINK - Configuring References to Bacnet Devices

Configuring / Programming
9.5 Configure BACnet client
PN/BACnet LINK
68 Operating Instructions, 10/2017, A5E39895543-AA
Check status and control address
On the "Status and control address" page, you can see the addresses in the process image
that contain the status byte and the control byte for the client functionality.
Adapting I/O addresses
The start and end addresses of the input and output data of the BACnet Client can be set via
the "I/O addresses" page. In addition, the address range can be assigned to an organization
block and a process image.
9.5.2
Configuring references to BACnet devices
In the TIA Portal, you have three options for configuring references to objects that are
located in other BACnet devices:
● Import of an EDE file
● Search for BACnet devices and the objects contained in them
● Manual
The possibilities mentioned are described below.