PN/BACnet LINK
90 Operating Instructions, 10/2017, A5E39895543-AA
Certificates and approvals
Note
Approvals are only valid when marked on the product
The specified approvals apply only when the corresponding mark is printed on the product.
You can check which of
the following approvals have been granted for your product by the
markings on the type plate.
The SIMATIC PN/BACnet LINK device complies with the requirements and protection
objectives of the following EC Directives.
The product is designed for operation in the following areas:
● Residential area according to EN 50491-5-1, EN 50491-5-2
● Industrial area according to EN 50491-5-3 and EN 61131-2 (programmable controllers)
EMC requirements:
Noise emission requirements
Interference immunity requirements
The product meets these requirements if you adhere to the installation guidelines and safety
instructions described in these operating instructions and in the System Manual for the S7-
1200 Automation System (https://support.industry.siemens.com/cs/ww/en/view/109741593).
The current approvals for the PN/BACnet LINK are listed in the Siemens Mall.
To Next Page
Loading...
