11 Loading New Firmware
B4A−75
CP 443-1 Advanced for Industrial Ethernet / Manual Part B4A
Release 01/2007
C79000-G8976-C193-06
How to React to an Aborted Download
Disturbances or collisions on the network can lead to packets being lost. In such
cases, this can lead to an interruption of the firmware download. The firmware
loader then signals a timeout or negative response from the module being loaded.
Repeat the download using the factory−set MAC address.
If you cannot start the download again following an aborted attempt, you should
turn off the entire rack and turn it on again. You can then trigger the firmware
download again within 10 seconds with the mode selector set to STOP. In this
case, you must always use the factory−set MAC address.
During this time, the CP indicates “Ready for Firmware Download”.
To Next Page
Loading...
