9/34
Siemens Building Technologies PXM10 operator unit CM110397en
Siemens Building Automation 31.08.2004
2.2.3 Info button
Figure 2-4 Info button
You can use the Info button to display a pop-up window
containing all the available information about the selected
line. You can close the pop-up window by pressing the Info
button (or Esc button) again.
2.2.4 Alarm button with alarm LED
Figure 2-5 Alarm button with alarm LED
The alarm LED lights up or flashes when an alarm or event is
tripped in the system. The alarm button takes you straight to
the alarm list.
Alarm
LED
Sym-
bols
Event
Flashing
Pending alarm, unacknowledged
(pop-up window and alarm list)
Incoming event (pop-up window only) Steady
light
Pending alarm, acknowledged, and
extended alarm, acknowledged but
not reset (alarm list)
Off No active alarms
Alarms are operated by use of the push-dial (see Section 5).
Alarm LED
response
Note
To Next Page
Loading...
