Siemens ET 200S - Wiring Terminal Modules with Fast Connect

Wiring and Fitting
5-11
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07
Wiring Terminal Modules with Fast Connect
1. Insert the unstripped cable in the round opening until it stops (the insulation
and conductor must form a flat surface).
2. Insert the screwdriver into the opening above the locking mechanism until it
stops.
3. Press the screw driver downwards until the locking mechanism reaches the
end.
Result: The cable is connected.
1
3
2
3 mm
Figure 5-5 Wiring Terminal Modules with Fast Connect
Note
If you want to reconnect a cable that has already been connected, you must first
cut it off.