Siemens ET 200S - Grouping of Motor Starters Within a Byte; Setup of the ET 200 S

Commissioning and Diagnostics
6-8
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07
Grouping of Motor Starters
MS MS MS
Setup:
Designation:
1st Step 2nd Step
Without “*”
Without “*”
With “*”
70
Input byte:
70
DI DI
70
Output
byte:
70
DI DI
Figure 6-3 Grouping of Motor Starters within a Byte
Configuration Example
The following example describes how to configure an ET 200S setup:
Setup of the ET 200S
Interface module
PM-E 24 VDC
2DI 24 VDC
4DO 24 VDC
2DI 24 VDC 4DI 24 VDC
2DO 24 VDC
2RO
2AI U
2AO I
2DO 24 VDC
PM-D
DS
DS DS
Bus term. elem.
Slot
1 2 345 6 78 91011 1314
Grouping in a single byte
PM-E 24 VDC
2DO 24 VDC 2DO 230 V
PM-E 120–230 VAC
2DO 230 V
15
16 17 18 1912
2AI U
2AO I
20 21
*
* As of IM151-1 BASIC; IM151-1 STANDARD 6ES7 151-1AA00-0AB0 with product level 5, 6ES7 151-1AA01-0AB0,
IM151-1 FO STANDARD and IM151-1 HIGH FEATURE
Figure 6-4 Setup of the ET 200S
Configuration Table in Your Configuration Software and Address Space
The byte addresses of the inputs and outputs can be freely selected (if the
configuration software supports this). The bit addresses result automatically from
the sequence of the grouped modules.