Siemens ET 200S - Releasing the Wiring of the Terminal Module with Fast Connect

Wiring and Fitting
5-12
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07
Releasing the Wiring of the Terminal Module with Fast Connect
1. Insert the screw driver into the opening under the locking mechanism until it
stops.
2. Use the screwdriver to lever and push the locking mechanism upwards.
3. The wiring is released: Remove the cable.
1
2
3
2
Figure 5-6 Releasing the Wiring of the Terminal Module with Fast Connect