Installation
4-14
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07
Applying Slot Number Labels and Color Identification Labels
Slot number labels:
1. Break the slot number label (1 to 63) off the strip.
2. Use your finger to press the slot number label onto the terminal module.
Color identification labels:
1. You can place the color identification labels in the opening next to the terminal
while they are still on the strip and then bend the strip back to pull them off.
2. Use your finger to press the color identification labels onto the terminal module.
Slot number
label
Color identifi-
cation labels
2
22
Figure 4-8 Applying Slot Number Labels and Color Identification Labels
Removing Slot Number Labels and Color Identification Labels
Slot number label:
1. Remove the electronic module from the terminal module.
2. Lever the slot number label out of its mount.
Color identification labels: Use a screwdriver to lever the color identification labels
out of their mounts.
To Next Page
Loading...
