Wiring and Fitting
5-28
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07
Table 5-1 Removing and Inserting Electronic Modules
Modules ConditionsRemoving and
Inserting
4 IQ-SENSE Yes The sensors can also be
replaced during operation.
These are then
parameterized automatically
by the electronic module.
1Count 24V/100kHz Yes The load voltage must be
1Count 5V/500kHz
switched off by means of an
external switch/fuse.
1SSI
external switch/fuse.
1STEP 5V/204kHz
2PULSE
1POS INC/Digital
1POS SSI/Digital
1POS INC/Analog
1POS SSI/Analog
1SI 3964/ASCII Yes –––
1SI Modbus/USS Yes –––
RESERVE Yes –––
To Next Page
Loading...
