Siemens ET 200S - Page 127

Commissioning and Diagnostics
6-3
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07
Device Database File
You configure the ET 200S distributed I/O system using the device database file
(*.GSD file). The ET 200S is integrated in your system as a standard slave by
means of the device database file. You can download the *.GSD file in either of the
following ways:
 From the Internet under http://www.ad.siemens.de/csi_e/gsd
 By means of a modem at telephone number +49 (911) 737972
The following *.GSD files are available:
 IM151-1 BASIC: “SIEM80F3.GSx”
 IM151-1 STANDARD: “SIEM806A.GSx”
 IM151-1 FO STANDARD: “SIEM806B.GSx
 IM151-1 HIGH FEATURE:”SIR380E0.GSx
Integrating the Device Database File in Your Configuration Software
Table 6-1 describes how to integrate the device database file in SIMATIC S7 or
SIMATIC S5 (COM PROFIBUS).
Table 6-1 Integrating the Device Database File in the Configuration Software
Step
STEP 7 as of V5.0, ServicePack 3 COM PROFIBUS, as of V5.1,
ServicePack 2, Hotfix 1
1
1 Start STEP 7, and call the Options "
Install New *.GSD Files menu
command from HW Config.
Copy the device database file from the
ET 200S to the COM PROFIBUS
directory: ...CPBV51\GSD (default)
Copy the bitmap file to the following
directory: ...CPBV51\BITMAPS
2 In the dialog that appears, select the
device database file to be installed
and then click OK.
Result: The field device is displayed
in the hardware catalog in the
PROFIBUS-DP directory.
Start COM PROFIBUS, and call the File
" Read device database file menu
command. Result: The ET 200S is
displayed in the hardware catalog in the
slave configuration section.
3 Configure the ET 200S using
STEP 7 (refer to the help system in
STEP 7).
Configure the ET 200S using
COM PROFIBUS (refer to the integrated
help system in COM PROFIBUS).
1
If you are using different configuration software: see the associated documentation