Siemens ET 200S - Page 223

Interface Modules
8-9
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07
Technical Specifications
Dimensions and Weight
Dimensions W H D
(mm) 45 x 119.5 x 75
Weight Approx. 150 g
Data for Specific Modules
Transmission rate 9.6; 19.2; 45.45; 93.75;
187.5; 500 kbps, 1.5 ; 3;
6; 12 Mbps
Bus protocol PROFIBUS-DP
Interface RS 485
SYNC capability Yes
FREEZE capability Yes
Manufacturer ID 80F3
H
Direct communication Yes
Clocking No
Max. output current of
the PROFIBUS-DP
interface (5, 6)
80 mA
Voltages, Currents, Potentials
Rated supply voltage of
the electronic
components (1L+)
1)
24 VDC
 Reverse polarity
protection
Yes
 Power failure
bypass
No
Isolation
 Between the
backplane bus and
electronic
components
No
 Between the
PROFIBUS-DP and
electronic
components
Yes
 Between the supply
voltage and
electronic
components
No
Permitted potential
difference (to the rail)
75 VDC, 60 VAC
Insulation tested with 500 VDC
Current consumption
from rated supply
voltage (1L+)
Approx. 70 mA
Power dissipation of the
module
Typ. 1.5 W
Status, Interrupts, Diagnostics
Interrupts None
Diagnostic function Yes
 Group error
 PROFIBUS-DP bus
monitoring
Red “SF” LED
Red “BF” LED
 Monitoring of the
power supply
voltage of the
electronics
Green “ON” LED
1)
Fusing the supply voltage:
– Fuse type: 24 V/2.5 A /type C
– Inrush current: 3.5 A