Power Modules
10-3
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07
!
Caution
Only connect the specified rated load voltage of 24 VDC to the TM-P terminal
module of the power module.
The connected rated load voltage must correspond to the supply voltage of the
electronic modules in the potential group.
Terminal Assignment
The following table illustrates the terminal assignment of the PM-E 24 VDC power
module for the different terminal modules:
Table 10-2 Terminal Assignment of the PM-E 24 VDC Power Module
View
Terminal Assignment Remarks
AUX1AUX1
MM
24 VDC24 VDC
24 VDC
TM-P15S23-A1 and PM-E 24 VDC
2
3
6
7
AUX1
84
AA
4
8
AA
24 VDC: Rated load
voltage
M: Ground
AUX1: Ground terminal or
usable as any voltage bus
up to the level of the load
voltage.
AUX1
AUX1
24 VDC
TM-P15S23-A0 and PM-E 24 VDC
MM
24 VDC24 VDC
2
3
6
7
AUX1
84
AA
4
8
AA
24 VDC: Rated load
voltage
M: Ground
AUX1: Ground terminal or
usable as any voltage bus
up to the level of the load
voltage.
AUX1 is used as PE.
To Next Page
Loading...
