Power Modules
10-6
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07
10.3 PM-E 24–48 VDC, 24–230 VAC Power Module
(6ES7 138-4CB10-0AB0)
Order Number
6ES7 138-4CB10-0AB0
Features
The PM-E 24–48 VDC, 24–230 VAC has the following characteristic features:
Monitors the supply voltage for all the electronic modules in the potential group.
The supply voltage is fed in by means of the TM-P terminal module.
Can be used universally and can be parameterized for DC and AC load voltage
for use with any electronic module.
Is required at least once for the ET 200S (to the right of the interface module).
Is additionally equipped with a replaceable fuse (5 mm x 20 mm).
3-mm screwdriver
Fuse
Figure 10-2 Replacing the Fuse
To Next Page
Loading...
