Siemens ET 200S - Page 274

Power Modules
10-8
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07
Terminal Assignment
The following table indicates the terminal assignment of the PM-E 24–48 VDC,
24–230 VAC power module for the different terminal modules:
View Terminal Assignment Remarks
M/ NM/ N
AUX1
24–48 VDC/ L1
AUX1
ACY
TM-P15S23-A1 and PM-E 24–48 VDC, 24–230 VAC
2
3
4
6
7
8
AUX1
24–48 VDC/ L1
24 VDC
AA
4
8
AA
24–48 VDC/ L1: Rated
load voltage
M/ N: Ground/neutral
conductor
AUX1: Ground terminal
or usable as any
voltage bus up to the
level of the load
voltage.
ACY
AUX1 AUX1
TM-P15S23-A0 and PM-E 24–48 VDC, 24–230 VAC
2
3
4
6
7
8
AUX1
24–48 VDC/ L1 24–48 VDC/ L1
M/ NM/ N
24 VDC
AA
4
8
AA
24–48 VDC/ L1: Rated
load voltage
M/ N: Ground/neutral
conductor
AUX1: Ground terminal
or usable as any
voltage bus up to the
level of the load
voltage.
AUX1 is used as PE.
ACY
TM-P15S22-01 and PM-E 24–48 VDC, 24–230 VAC
2
3
6
7
AUX1
24–48 VDC/ L1 24–48 VDC/ L1
M/ NM/ N
24 VDC
24–48 VDC/ L1: Rated
load voltage
M/ N: Ground/neutral
conductor