Siemens ET 200S - Page 280

Digital Electronic Modules
11-4
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07
Parameters for Digital Output Modules
Table 11-2 Parameters for Digital Output Modules
2DO 24
VDC/
0.5 A High
Feature
2DO
24–230 VAC/
1 A
2RO NO/NC
24–48 VDC/
5 A
2DO/ 4DO
24 VDC/
0.5 A ST
Value Range Default Applicabil-
2DO 24
VDC/
2 A High
Feature
2RO NO
24–120 VDC/
5 A
24–230 VAC/
5 A
24–230 VAC/
5 A
2DO/ 4DO
24 VDC/
2 A ST
ity
Reaction to CPU/Master STOP –––  Switch
substitute
value
 Keep last
value
Substitute
a value
Module
Substitute value
1
–––  “0”
 “1”
“0” Channel
--- Diagnostic Inter-
rupt
–––  Disable
 Enable
Disable Module
Diagnos-
tics: Wire
break
–––  Disable
 Enable
Disable Channel
Diagnostics:
Short-circuit
to M
–––  Disable
 Enable
Disable Channel
1
If the IM151-1/ IM151-1 FO Standard is deenergized, the digital output modules do not produce any substitute
values. The value that is output = 0.
Hardware interrupt
This parameter enables the hardware interrupts for the module.
Input Delay
You can use this parameter to suppress signal interference. Changes to the signal
are detected once the set time has elapsed.
Trigger for hardware interrupt, rising edge
This parameter allows you to enable a hardware interrupt at a rising edge (of a
signal status change) for each channel.