4 IQ-SENSE
13-5
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07
Operating Principle
The following figure illustrates how the synchronization group parameter works:
4 IQ-SENSE
PM
Interface
module
12341
Parameters
Synchronization
group
Slot1234 56
It is only possible for the sensors of the modules in
slots 2 and 6 to interfere with one another because
they are in the same synchronization group: group 1.
Figure 13-1 Synchronization group
Note
When you install sensors of the same synchronization group, you must ensure
that the minimum clearance is adhered to (see the sensor information leaflet) to
prevent any interference between the sensors.
13.1.3 Sensor Type Parameter
Features
You use this parameter to set the sensor type for each channel.
Reflex sensor
Diffuse sensor
Deactivated
To Next Page
Loading...
