14-1
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07
RESERVE
Order Number
6ES7 138-4AA00-0AA0 (installation width 15 mm)
6ES7 138-4AA10-0AA0 (installation width 30 mm)
Features
The RESERVE module has the following characteristic features:
Suitable for all TM-E terminal modules (installation widths 15 mm and 30 mm)
Reserves a slot for any electronic module slot. Insert the RESERVE module in
the reserved slot of the ET 200S configuration.
Note
Note the following in the IM 151 (as of 6ES7 151-1AA01-0AB0), IM 151 FO
and IM 151/ CPU:
If you remove an electronic module from the ET 200S during operation and
insert a reserve module in its place, you must then switch the supply voltage to
the interface module OFF and ON.
Note with the IM 151 (6ES7 151-1AA00-0AB0):
The reserve module cannot be used in the ET 200S.
Parameter Assignment
In STEP 7 or COM PROFIBUS, parameterize the electronic module you want
to use for future applications, such as 4DI DC High Feature on the slot of the
RESERVE module.
– Drag the module to the configuration table
– Set the parameters
14
To Next Page
Loading...
