Siemens ET 200S - Page 537

C-1
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07
Address Space of the Input and Outputs of
the ET 200S
Table C-1 Inputs and Outputs for the ET 200S
Module
Address Space of the
Inputs
Address Space of the
Outputs
Without
Grouping
With
Grouping
1
Without
Grouping
With
Grouping
1
Digital input modules 1 byte 2 bits (2DI)
4 bits (4DI)
––– –––
Digital output modules ––– ––– 1 byte 2 bits (2DI)
4 bits (4DI)
Analog input modules 4 bytes ––– –––
Analog output modules ––– ––– 4 bytes
1Count 24V/100kHz 8 bytes 8 bytes
1Count 5V/500kHz 8 bytes 8 bytes
1SSI 8 bytes 8 bytes
1SSI fast 4 bytes –––
1STEP 5V/204kHz 8 bytes 8 bytes
2PULSE 8 bytes 8 bytes
1POS INC/Digital 8 bytes 8 bytes
1POS SSI/Digital 8 bytes 8 bytes
1POS INC/Analog 8 bytes 8 bytes
1POS SSI/Analog 8 bytes 8 bytes
1SI 3964/ASCII serial
interface module
4/8 bytes 4/8 bytes
1SI Modbus/USS serial
interface module
4/8 bytes 4/8 bytes
4 IQ-SENSE (standard) 1 byte 4 bits –––
4 IQ-SENSE (Enhanced) 4 bytes 4 bytes
Direct-on-line starter 1 byte 4 bits 1 byte 4 bits
Reversing starter 1 byte 4 bits 1 byte 4 bits
1
See Section 6.1 (on configuring the ET 200S)
C