Siemens ET 200S - Page 79

Configuration Options
3-31
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07
Table 3-8 Parameter Length in Bytes
Module ParametersModuleParameters
2DO 24 VDC/0.5 A Standard
4DO 24 VDC/0.5 A Standard
1 byte 1SSI 8 bytes
2DO 24 VDC/2 A High Feature 3 bytes 1STEP 5 V/204 kHz 7 bytes
2DO 24 VDC/2 A Standard
4DO 24 VDC/2 A Standard
1 byte 2PULSE 16 bytes
2DO 24–230 VAC/1 A 3 bytes 1POS INC/Digital
1POS SSI/Digital
1POS INC/Analog
1POS SSI/Analog
16 bytes
2RO NO 24–120 VDC/5 A,
24–230 VAC/5 A
3 bytes 1SI 3964/ASCII
1SI Modbus/USS
4/8 bytes
2AI U Standard
2AI U High Feature
4 bytes 4 IQ-SENSE 16 bytes
2AI U High Speed 12 bytes
(4 bytes*****)
RESERVE ––– Motor starter STANDARD 3 bytes
Motor starter
HIGH FEATURE
Byte 12
* Clocking is activated.
** When used as 2AI RTD Standard
*** When used as 6ES7 134 4GB50-0AB0
**** When used as 6ES7 134 4FB50-0AB0
***** When used as 6ES7 134 4GB60-0AB0
 Address space: depends on the DP master
– The IM151-1 BASIC interface module supports a maximum of 88 input bytes
and 88 output bytes.
– The IM151-1 STANDARD / IM151-1 FO STANDARD interface modules
support a maximum of 128 input bytes and 128 output bytes.
– The IM151-1 HIGH FEATURE interface module supports a maximum of 244
input bytes and 244 output bytes.