Siemens FCM2041-U3 - Page 24

CHAPTER 2 | FCM2041-U3 OPERATOR INTERFACE MANUAL
REPORT MODE
2-5
Menu:Report:Configuration:CustMsg:Settings
PHY:FireFinder@1
Cancel
Node
Module
SubModule
Device
None
All
Figure 2-3
Report Settings Selections
When the Settings have been completed, press the Apply soft key to display the
status screen showing the settings that were made to generate the report. See
Figure 2-4.
Menu:Report:Configuration:CustMsg
PHY:FireFinder@1
Custom Message Report
AT: FireFinder@1
Cancel Settings View
SETTINGS:
Node: All
Module: ZIC-4A
SubModule: All
Device: All
Figure 2-4
Custom Message Report Settings Status
Press the View soft key to display the list of Custom Messages. As the system reads
the information to create the report it might display the message Acquiring Data and
display the percentage of report completion. See Figure 2-5.