5BInstallation
FDM223/FDM224
1. Connect the feeding line to the terminals in the call point unit (1), in accordance
with the connection diagram.
2. When inserting the call point unit (1) into the housing (2), pay attention to the
feeding line.
3. Place the call point unit (1) into the housing (2) with the terminals pointing
upwards; then fix it with two screws.
4. In wet zones, use a seal (3) (DMZ1197-AD).
5. Close the housing (2) with the lid (4).
4
1
3
2
20
007002_e_en_--.doc
Fire Safety & Security Products 11.2007
To Next Page
Loading...
