Standards and directives complied with
2
12 | 40
Modules and spare parts
● Components and spare parts must comply with the technical specifications
defined by Siemens. Only use products specified or recommended by
Siemens.
● Only use fuses with the specified fuse characteristics.
● Wrong battery types and improper battery changing lead to a risk of explosion.
Only use the same battery type or an equivalent battery type recommended by
Siemens.
● Batteries must be disposed of in an environmentally friendly manner. Observe
national guidelines and regulations.
Disregard of the safety regulations
Before they are delivered, Siemens products are tested to ensure they function
correctly when used properly. Siemens disclaims all liability for damage or injuries
caused by the incorrect application of the instructions or the disregard of danger
warnings contained in the documentation. This applies in particular to the following
damage:
● Personal injuries or damage to property caused by improper use and incorrect
application
● Personal injuries or damage to property caused by disregarding safety
instructions in the documentation or on the product
● Personal injury or damage to property caused by poor maintenance or lack of
maintenance
2.3 Standards and directives complied with
A list of the standards and directives complied with is available from your Siemens
contact.
2.3.1 Current Firmware Version Status
NOTICE
Not the current firmware version status of a newly installed fire detection
installation
Possible limitations for the configuration or use of devices.
● Compare the firmware version of a newly installed fire detection installation
with the currently approved firmware version status.
● Use the currently approved firmware version status.
● Update the firmware if required, in accordance with the chapter 'FW update
for main CPU and additional CPUs' in document 009052; see chapter
To Next Page
Loading...
Need help?
General
