Siemens FT2010 User Manual

Building Technologies
Fire Safety
6.5
Switching an object on / off
To avoid
e.g., for the purpose of maintenance work.
When a part of the '
In which
the detectors used as well as on possible deceptive phenomena such as smoke,
dust, heat or vapour.
You can use the <'
the touch of a button.
WARNING
System parts that have been switched off make it impossible to acquire and
process alarms or faults!
Fire may spread unhindered.
●
Deploy staff to monitor the
●
You must switch deactivated parts of the '
If a deactivated '
indicated as deactivated.
↑
Switching off the '
ϖ
Before you may switch off the pre
operation by means of the '
1.
Turn the '

2.
Press <'

The pre

LED '
Switching on the object
ϖ
The object is isolated and the LED '
1.
Turn the '

2.
Press <'

The pre

LED '
Switching an object on / off
Switching an object on / off
To avoid
↑ false alarms, you can switch off parts of a ↑
e.g., for the purpose of maintenance work.
When a part of the '
Site' is switched off, the LED '
ISOLATION
In which
situations the pre-
configured object should be switched off, depends on
the detectors used as well as on possible deceptive phenomena such as smoke,
dust, heat or vapour.
You can use the <'
Section' 'OFF'> button to ↑
switch off a pre
the touch of a button.
WARNING
System parts that have been switched off make it impossible to acquire and
process alarms or faults!
Fire may spread unhindered.
Deploy staff to monitor the
deactivated area.
You must switch deactivated parts of the '
Site
' back on as soon as possible.
If a deactivated '
Zone
' is the only '
Zone
' in a '
Section
', the '
indicated as deactivated.
Switching off the '
Section'
Before you may switch off the pre
-
configured object, you must release
operation by means of the '
Key switch'.
Turn the '
Key switch' into a horizontal position.
Operation is released.
Press <'
Section' 'OFF'>.
The pre
-configured object is isolated.
LED '
ISOLATION' on.
Switching on the object
The object is isolated and the LED '
ISOLATION
' is on.
Turn the '
Key switch' into a horizontal position.
Operation is released.
Press <'
Section' 'OFF'>
The pre
-configured object is switched on.
LED '
ISOLATION' off.
Operation
Switching an object on / off
6
23 | 40
009310_l_en_
--
2018
-
08
-
29
'Site' in certain situations,
ISOLATION
' is on.
configured object should be switched off, depends on
the detectors used as well as on possible deceptive phenomena such as smoke,
switch off a pre
-configured object at
System parts that have been switched off make it impossible to acquire and
' back on as soon as possible.
', the '
Section
' is also
configured object, you must release
' is on.

Siemens FT2010 Specifications

General

Brand	Siemens
Model	FT2010
Category	Touch terminals
Language	English