Indicating and scrolling in lists
6
25 | 40
Building Technologies
6.7.2 Indicating fault list
If a 'Fault' has occurred and is the only 'Event' in the configured ↑ visibility, this
'Event' is shown on the display directly.
If other 'Events' or conditions have occurred, such as 'Isolation' or an 'ALARM', the
most important 'Event', or the most important condition, respectively, is indicated
on the display.
Indication of the fault list
ϖ A button is configured with the 'Show' 'Fault' function
ϖ The button is labelled accordingly
κ Press <'Show' 'Fault'>.
The fault list is indicated on the display.
Example for a fault list with two 'Faults':
002 Faults
––––
Device missing
Office Room 123
Dev.location fault
Corridor 3rd floor
––––––––––––––––––––––––––––––––
––
Zone
Zone
––––––––––––––––––––––––––
–
1/1
3/1
–––
Table 2: Example of fault list
See also
1 Maximum number of events that can be displayed [➙ 14]
To Next Page
Loading...
Need help?
General
