28
First steps
Gigaset A580 IP / GBR / A31008-xxxx-xxxx-x-xxxx / starting.fm / 24.03.2010
Version 8, 03.09.2008
Icons on the idle display
The following is displayed:
u the internal number, e.g. INT 1.
u the quality of the reception signal between base station and handset
(signal strength):
– good to poor: ÐiÑÒ
– no reception: | flashes
u battery charge status:
– = e V U (flat to full)
– = flashes: batteries almost flat
– e V U flashes: charging procedure
No connection to the Internet/VoIP server
If one of the following messages is displayed instead of the internal name after the
connection assistant is closed, errors have occurred:
u Server not accessible
u SIP registration failed
Below you will find possible causes and measures you can take.
Server not accessible
The phone has no connection to the Internet.
¤ Check the cable connection between the base station and the router (the LED
on the base station must light up) and the connection between the router and
the Internet connection.
¤ Check whether the phone is connected to the LAN.
– It may not have been possible to dynamically assign an IP address to the
phone
or
– You have assigned a static IP address to the phone that has either already
been assigned to another LAN subscriber or does not belong to the router's
address block.
¤ Press the paging key on the base station. The IP address appears on the hand-
set display.
¤ Press the talk key on the handset to end paging call.
¤ Start the Web configurator with the IP address.
¤ If no connection can be established, change the settings on the router (acti-
vate DHCP server) or the phone's IP address.
To Next Page
Loading...
