Siemens Gigaset S790 - Setting up the Base and Charger (if Included); Connecting the Base

10
First steps
Gigaset S790-S795 / en / A31008-M2121-R301-2-3S19 / starting.fm / 22.04.2010
Version 4.1, 21.11.2007
Setting up the base and charger (if included)
The base and charger are designed for use in dry rooms in a temperature range of
+41°F to +113°F.
¤ Set up the base at a central point in the building on a level, non-slip surface or
mount the base (Gigaset S790 only) or charger on the wall (
¢ page 72).
The phone's feet do not usually leave any marks on surfaces. However, due to the
multitude of different varnishes and polishes used on today's furnishings, the
occurrence of marks on the surfaces cannot be completely ruled out.
Please note:
u Never expose the telephone to the influence of heat sources, direct sunlight or
other electrical devices.
u Protect your telephone from moisture, dust, corrosive liquids and fumes.
Connecting the base
¤ First connect the
power adapter 1.
¤ Then connect the
telephone jack 2
and insert the cables
into the cable ducts.
Please note:
u The power adapter
must always be connected, as the phone will not operate without.
u Use only the power adapter and phone cord supplied. Pin connections on tele-
phone cables can vary (
¢ page 62).
Please note
Pay attention to the range of the base.
This is up to 984 feet in unobstructed outdoor areas and up to 165 feet inside
buildings. The range is reduced when Eco Mode (
¢ page 44) is activated.
1
1
1
2