Siemens Gigaset S790 - Setting Keypad Illumination; Activating;Deactivating Auto Answer; Changing the Speaker;Earpiece Volume; Setting a Handsfree Profile

54
Handset settings
Gigaset S790-S795 / en / A31008-M2121-R301-2-3S19 / registr_sett.fm / 22.04.2010
Version 4.1, 21.11.2007
Select On or Off.
§Save§ Press the display key.
Setting keypad illumination
The brightness of the keypad illumination
can be set to one of five levels.
v
¢
Ï
¢ Display + Keypad
¢ Keypad Illumination
The current setting is displayed.
¤ You can enter data in the following fields:
Brightness:
Select 1 (darkest) to 5 (brightest).
§Save§ Press the display key.
Activating/deactivating
auto answer
If you activate this function, when you
receive a call you can simply lift the handset
out of the base/charger without having to
press the talk key c.
v
¢
Ï
¢ Telepho ny ¢ Auto Answer
§Change§ Press display key (³=on).
Changing the speaker/
earpiece volume
You can set the speaker volume for speaker
mode and the earpiece volume to five differ-
ent levels.
During a conversation via the earpiece or in
speaker mode:
ø/ ÷ Press the side key to call up the
Handset Volume menu.
Change the volume by pressing
ø (louder) or ÷ (quieter).
or
t Press the control key to call up
the Handset Volume menu. Set
the earpiece or speaker volume
by pressing r.
The setting will automatically be saved after
approximately 3 seconds, if not then press
the display key
§Save§.
If t is assigned to another function:
§Options§ Open menu.
Volume Select and press §OK§.
Configure setting (see above).
Setting a handsfree profile
In idle state, you can set various handsfree
profiles to optimally adapt your phone to
your environment.
Profile 1
The optimum setting for most connec-
tions and set as default.
Profile 2
Optimum volume in handsfree mode.
However, this means that the participants
cannot speak at the same time as the per-
son speaking is given preferential trans-
mission (making two-way conversations
difficult).
Profile 3
Optimises two-way conversations, both
callers can hear each other, even if they
talk at the same time.
Profile 4
Optimised for special connections. If the
default setting (profile 1) does not pro-
vide optimum sound, please give this a
try.
v
¢
Ï
¢ Audio Settings
¢ Handsfree Profiles
Select handsfree profile (1 to 4) and press
§Select§.
Please note
With the On setting, the standby time
of the handset can be significantly
reduced.
•
Please note
u The settings for the earpiece also
apply to a connected headset.
u You can also set the call volume using
the menu (
¢ page 26).