59
Connecting the base to the PABX
Gigaset S790-S795 / en / A31008-M2121-R301-2-3S19 / pabx.fm / 22.04.2010
Version 4.1, 21.11.2007
Connecting the base to
the PABX
The following settings are only necessary if
your PABX requires them; see the PABX user
guide.
Dialing modes and recall
The current setting is indicated by Ø.
Changing the dialing mode
The following dialing modes can be
selected:
u Tone dialing (DTMF)
u Pulse dialing (PD).
v ¢
Ï
¢ Telepho ny ¢ Dialing Mode
s Select dialing mode and press
§Select§ (Ø = selected).
Setting recall
Your phone is preset at the factory for oper-
ation on the main connection. For operation
on a PABX, you may have to change this
value. Please refer to the user guide for your
PAB X.
v
¢
Ï
¢ Telepho ny ¢ Flash
s Select recall and
press
§Select§
(
Ø = set value). Possible values
are:
80 ms, 100 ms, 120 ms, 180 ms,
250 ms, 300 ms, 400 ms, 600 ms,
800 ms.
Setting pauses
Changing the pause after line
seizure
You can change the length of the pause that
is inserted between pressing the talk key c
and sending the number.
v Open the main menu.
*#Q5#L
Press keys.
~ Enter number for the length of
the pause (1 = 1 sec.; 2 = 3 secs.;
3 = 7 secs.) and press
§OK§.
Change pause after recall key
You can change the length of the pause if
your PABX requires this (refer to the user
guide for your PABX).
v Open the main menu.
*#Q5#2
Press keys.
~ Enter a number for the length of
the pause (1 =800ms;
2 =1600ms; 3 = 3200 ms) and
press
§OK§.
Switching temporarily to
tone dialing (DTMF)
If your PABX still operates with pulse dialing
(PD), but you need tone dialing for a connec-
tion (e.g., to listen to the network mailbox),
you must switch to tone dialing for the call.
Prerequisite: You are conducting a call or
have already dialed an external number.
* Press the star key.
After the call ends, pulse dialing is automati-
cally activated again.
To Next Page
Loading...
